How to build a house in 6 steps


How to build a house in 6 steps, Have you ever wondered how your home was built? In this article, I'm going to explain how a story is constructed in ten steps. These steps do not include all the details that go into a House, but will give you a general understanding of how your home is built.

1. Excavation work

The first thing you do, is the excavation. This requirement means that the lot is free of debris and dig a hole in the ground for the basement of the House. To excavate the pit right size workers use a floor plan that is included with home projects. Once you set the size and shape of the House, a back-hoe digs a hole big enough to pour concrete foundations and Foundation.

2. Concrete foundations

The footings are the main support for the House and help distribute the weight of the House into the ground. The size of a plan may vary depending on soil conditions and the size of the House. Foundations are generally made of poured concrete. Wood is used to create a mold so that the desired size of the foot can be done. Lumber on his side is normally prepared according to a basic plan that comes with home projects. Once the mold is ready, the concrete is poured into it, and then level off off on top. Making the top smooth, gives a solid foundation for the area to be paid.

3. Concrete Foundation

The foundation walls are those that provide alternative support for the House. They are also made of poured concrete that is created using formwork. Housing are sections that are normally made from metal and wood that can be put in place to create the desired shape of the concrete. A Foundation is concrete walls can be seen in an unfinished basement. Once the foundation walls are poured and dried, fill the extra space outside the walls with filling. The floor system is now ready to be built.

4. system plan

A floor system is made of wood, unlike the concrete foundations and concrete foundation. The wood used is usually a 2 x 12 or 2 x 10. The wood is placed on its side and run through foundation walls parallel to each other. These are called floor joists. They are spaced some distance from each other to provide even support plan. To keep them in place are nailed to a header that is wood the same size but put perpendicular to the outer edges. If the basement is too large then the posts and beams are put in to help support the floor.

5. Floor sheathing

The floor system provides good support, but the only problem is that all the holes between the lumber. This is where the floor sheathing comes into play is made of sheets of wood that are drilled in the floor joist to keep it secure. Are installed perpendicular to joists so you can support more weight. When the House is complete, the homeowners choice flooring will be installed above the floor sheathing. Now workers are ready for installation.

6. Walls

When we talk about position of walls in a House there are two types, external walls and internal walls. The outer walls run along the exterior of the House and are thicker to withstand the wind and allow insulation to be installed. The inner walls are inside and have no need to be as often. When it comes to the structural strength of walls again two types. Load-bearing walls and non-bearing walls. Bearing walls are reinforced because they have to hold anything over the wall if it is a roof or another plane (in this case it is a roof). Non load-bearing wall do not provide any structural support for the home, because they are typically only used for the separate walls.

When installing the walls, you look at the housing projects and the layout in which the walls are to be placed. To build the walls that before building them on the ground. Their wood which is spaced (these are called studs wall) and then drilled in a top and bottom plate. The top and bottom plate can be compared with the headers on a floor system. Both help maintain the timber on site and provide strength to the wall. Once they are built, the workers then lift the walls into position and practiced in the floor system. The wall cavity then be stuffed with insulation and covered with a vapor barrier to keep out moisture. However, the insulation cannot be installed up to the wall finish is applied.